Question: How do you hook up a Blue Ox tow bar?

How does a tow bar hook up?

0:412:16Hooking up a Tow Bar - YouTubeYouTubeStart of suggested clipEnd of suggested clipMaking sure that you fold the ring of the quick lock pin to the side of the pin that allows the ringMoreMaking sure that you fold the ring of the quick lock pin to the side of the pin that allows the ring to snap against the pin attach. The safety cable ends to the anchors on the vehicles baseplate.

Does a blue ox tow bar need to be level?

The safe zone is 3 either up or down that the tow bar should be above or below the receiver on your motorhome, but its best to get the tow bar as level as possible.

Can you back up with a Blue Ox hitch?

One piece of equipment that you can stay connected to while backing up is the SwayPro and TrackPro from Blue Ox. Both of these products are weight distribution hitches that allow you to back up without disconnecting.

How does the Blue Ox work?

SwayPro works by using tension on the spring bars to keep them taut. The attached brackets ensure that the pressure from the spring bars keeps the trailer in alignment with the towing vehicle. Blue Ox uses a high-quality steel in the spring bar design to ensure safety and durability.

Can I install my own tow bar?

Can I fit my own towbar? The short answer is no. Not only is fitting it by yourself a huge safety concern, but you could also be invalidating the towbar or car manufacturers warranty by doing the work yourself. Fitting a towbar to your car is no easy task, and should never be done by an amateur.

How hard is it to install a tow bar?

Attaching Your Tow Bar. Once youve picked your tow bar and electrics, youre ready to get started. The entire process shouldnt take more than a couple of hours, and the job will be a lot easier if you can raise the car on a ramp, above an inspection pit, or on a couple of jacks and axle stands.

Can you reverse with a Blue Ox tow bar?

One piece of equipment that you can stay connected to while backing up is the SwayPro and TrackPro from Blue Ox. Both of these products are weight distribution hitches that allow you to back up without disconnecting.

Can a towbar fit without electricity?

Do I need electrics for my towbar? Yes, you will need electrics for your towbar. Anybody who fits a towbar to your vehicle without an electric kit is breaking the law. Here at Witter Towbars, we would never fit a towbar without an electric kit.

Can you install a tow bar yourself?

In most cases yes you can just buy a wiring harness. All of our towbar kits are complete and ready to install however we can supply any individual item from the kit to suit your needs.

The towbar must be installed correctly under the EC94/20 regulations as an incorrectly installed towbar is dangerous and illegal. Provided the towbar is installed in accordance with the manufacturers instructions, it is perfectly permissible to fit your own towbar to your car.

Tell us about you

Find us at the office

Chanco- Cordoza street no. 78, 65475 West Island, Cocos (Keeling) Islands

Give us a ring

Kriti Uminski
+72 304 539 36
Mon - Fri, 9:00-21:00

Write us